Yamaha YFM125GZ Instrukcja Właściciela Pobierz pdf (Strona 76)

8-10

2. Clean the surface of the spark plug gasket

and its mating surface, and then wipe off any

grime from the spark plug threads.

3. Install the spark plug with the spark plug

wrench, and then tighten it to the specified

torque.

TIP

If a torque wrench is not available when installing

a spark plug, a good estimate of the correct torque

is 1/4–1/2 turn past finger tight. However, the spark

plug should be tightened to the specified torque as

soon as possible.

4. Install the spark plug cap.

EBU23266

Engine oil

The engine oil level should be checked before

each ride. In addition, the oil must be changed at

the intervals specified in the periodic maintenance

and lubrication chart.

To check the engine oil level

1. Place the ATV on a level surface.

2. Check the engine oil level on a cold engine.

TIP

If the engine was started before checking the oil

level, be sure to warm up the engine sufficiently,

and then wait at least ten minutes until the oil set-

tles for an accurate reading.

3. Remove the engine oil filler cap, and then

wipe the engine oil dipstick off with a clean

rag.

Tightening torque:

Spark plug:

12.5 Nm (1.3 m·kgf, 9.0 ft·lbf)

1. Engine oil ﬁller cap

2. Dipstick

✤✰✬✤✩ ✤✣  

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 137 138

Brak uwag

Yamaha YFM125GZ Instrukcja Właściciela Strona 76