Yamaha F6D Instrukcja Właściciela Pobierz pdf (Strona 43)

Operation

3. Reposition the rod in the desired hole.

To raise the bow (“trim-out”), move the rod

away from the transom.

To lower the bow (“trim-in”), move the rod to-

ward the transom.

Make test runs with the trim set to different an-

gles to find the position that works best for

your boat and operating conditions.

WARNING

EWM00400

● Stop the engine before adjusting the

trim angle.

● Use care to avoid being pinched when

removing or installing the rod.

● Use caution when trying a trim position

for the first time. Increase speed gradu-

ally and watch for any signs of instability

or control problems. Improper trim an-

gle can cause loss of control.

TE:

The outboard motor trim angle can be

changed approximately 4 degrees by shifting

the trim rod one hole.

EMU27901

Adjusting trim angle (power tilt

models)

WARNING

EWM00750

● Be sure all people are clear of the out-

board motor when adjusting the tilt an-

gle, also be careful not to pinch any

body parts between the drive unit and

clamp bracket.

● Use caution when trying a trim position

for the first time. Increase speed gradu-

ally and watch for any signs of instability

or control problems. Improper trim an-

gle can cause loss of control.

● Use the power tilt switch located on the

bottom engine cowling (if equipped)

only when the boat is at a complete stop

with the engine off.

Tilt the engine to the desired angle using the

power tilt switch.

U60R10E0.book Page 37 Monday, June 21, 2004 9:34 AM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 86 87

Komentarze do niniejszej Instrukcji

Brak uwag

Yamaha F6D Instrukcja Właściciela Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Silnik Yamaha F6D